Metrologic IS4225 Scanner Betriebsanweisung

METROLOGIC INSTRUMENTS, INC.IS4225 ScanGlove®Laser Bar Code ScannerInstallation and User’s Guide00-02258B_Front_Cover.qxd 5/30/2007 3:43 PM Page 1

6 SIGNAUX OPTIQUES Sur la partie supérieure du scanner se trouvent une diode LED rouge et une diode LED verte. Quand le scanner est sous tension,

7OPTISCHE ANZEIGEN Auf der Oberseite des Scanners befinden sich eine rote und eine grüne Leuchtdiodenanzeige. Ist der Scanner eingeschaltet, so ge

8 SEGNALI OTTICI Sulla parte superiore dello scanner si trovano due diodi luminosi: uno rosso e uno verde. Quando lo scanner è inserito, i diodi

9AUDIBLE INDICATORS The scanner provides sounds to signal certain conditions. To change the volume (four settings are available) or turn the beepe

10 LABELS Each IS4225 has a serial number label and a laser class label on the bottom of the unit. These labels provide important information like

11MAINTENANCE Smudges and dirt can interfere with the proper scanning of a bar code. Therefore, the output window will need occasional cleaning.

12 INFRARED (IR) OBJECT SENSOR An infrared (IR) device located behind the window initiates the scanning process. The IR sensor is active as long a

13Scan Field The depth of field for the scanner is 12.7 mm to 203 mm (.5" to 8") from the face of the output window for .33 mm (13 mil)

14 SPECIFICATIONS IS4225 SPECIFICATIONS OPERATIONAL Light Source: 650 nm ± 10nm VLD Depth of Field: 12.7 mm to 203 mm (.5" to 8") f

15DEFAULT SETTINGS Many functions of the scanner can be "configured", that is enabled or disabled. The scanner is shipped from the facto

Copyright © 2007 by Metrologic Instruments, Inc. All rights reserved. No part of this work may be reproduced, trans

16 DEFAULT SETTINGS PARAMETER DEFAULTRS232 LIGHT PEN KEYBOARD WEDGE USB ACK/NAK  XON/XOFF *  No Intercharacter Delay    1 Millise

17DEFAULT SETTINGS PARAMETER DEFAULTRS232 LIGHT PEN KEYBOARD WEDGE USB RSS Limited ID “]e0” *     RSS Limited App ID “01” *     RS

18 DEFAULT SETTINGS PARAMETER DEFAULTRS232 LIGHT PEN KEYBOARD WEDGE USB Mod 43 Check Digit Code 39     Transmit Mod 43 Check Digit Code 3

19DEFAULT SETTINGS PARAMETER DEFAULTRS232 LIGHT PEN KEYBOARD WEDGE USB BIO DATA Mode   Golden Bountiful Formatting   Intermec Polling

20 DEFAULT SETTINGS PARAMETER DEFAULTRS232 LIGHT PEN KEYBOARD WEDGE USB Alt Mode  Auto Detection or Caps Lock  User-Defined Caps Loc

21TROUBLESHOOTING GUIDE The following guide is for reference purposes only. Contact a Metrologic representative at 1-800-ID-METRO or 1-800-436-387

22 REGULATORY COMPLIANCE Safety ITE Equipment IEC 60950-1, EN 60950-1 Laser Laser Class 2: IEC 60825-1:1993+A1:1997+A2:2001 EN 60825-1:1994+A

23REGULATORY COMPLIANCE EMC Emissions FCC Part 15, ICES-003, CISPR 22, EN 55022 Immunity CISPR 24, EN 55024 Changes or modifications not expres

24 REGULATORY COMPLIANCE EMC Changes or modifications not expressly approved by the party responsible for compliance could void the user’s autho

25PATENTS This METROLOGIC product may be covered by, but not limited to, one or more of the following U.S. Patents: U.S. Patent No. 5,260,553; 5,

iiTABLE OF CONTENTS Introduction... 1 Scann

26 LIMITED WARRANTY The IS4225 ScanGlove® scanners are manufactured by Metrologic at its Blackwood, New Jersey, U.S.A. facility. The IS4225 scann

27INDEX A application ...1 audible...5–9 autodiscriminates...

28 INDEXR razzberry tone ...9, 15 red LED ...4, 5–9 rights...

May 2007 Printed in the USA 00-02258C

1INTRODUCTION The IS4225 ScanGlove® is a fully automatic single-line laser barcode scanner. The ScanGlove is designed to be used as a “hands-fre

2 SCANNER INSTALLATION 1. Turn off power to the host system. 2. Connect the communication cable to the proper port on the host device. 3. Tu

3SCANNER CONFIGURATION TO THE HOST SYSTEM The IS4225 is shipped from the factory pre-configured to a set of default parameters. It may be necessa

4 PARTS OF THE SCANNER Figure 1. Scanner Parts Item No. Description  Green LED When a bar code is read successfully, the green LED will flas

5VISUAL INDICATORS There is a red and a green LED located on the top of the scanner. When the scanner is on, the flashing or constant, illuminati