Metrologic MS9540 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 21)

INDICATORS

Audible

When the Voyager is in operation, it provides audible feedback. These sounds

indicate the status of the scanner. Eight settings are available for the tone of the

beep (normal, 6 alternate tones and no tone). To change the beeper tone, refer

to the MetroSelect

Single-Line Configuration Guide or MetroSet2’s help files.

One Beep

When the scanner first receives power, the green* LED will turn

on, then the red* LED will flash and the scanner will beep once.

The red LED will remain on for the duration of the beep. The

scanner is ready to scan.

When the scanner successfully reads a bar code, the red LED will

flash and the scanner beeps once (if configured to do so). If the

scanner does not beep once and the red light does not flash, then

the bar code has not been successfully read.

Razzberry Tone

This tone is a failure indicator. Refer to “Failure Modes"

on page 19.

Two Beeps – On Power Up

When a Flash ROM upgrade is needed, the scanner will beep

twice followed by alternating flashes of the green and red LEDs.

Three Beeps - During Operation

When entering configuration mode, the red LED will flash while the

scanner simultaneously beeps three times. The red and green

LEDs will continue to flash while in this mode. Upon exiting

configuration mode, the scanner will beep three times, and the

LEDs will stop flashing.

When configured, 3 beeps can also indicate a communications

timeout during normal scanning mode.

When using one-code-configuration, the scanner will beep three

times (the current selected tone), followed by a short pause then

by a high tone and a low tone. This tells the user that the single

configuration bar code has successfully configured the scanner.

Three Beeps - On Power Up

This is a failure indicator. Refer to “Failure Modes” on page 19.

* In some custom units the standard green LED has been replaced with a blue LED and

the red LED has been replaced with a white LED.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Keine Kommentare

Metrologic MS9540 Anleitung zur Fehlerbehebung Seite 21